Upgrade Pipo P1 – Upgrade Guide

Following firmware upgrade steps are written for Pipo P1 (RK3288).

Attention!

  • Make sure you download the correct firmware version for your hardware, using wrong image file will brick the device
  • Backup your data before continuing, storage will be formatted during upgrade
  • Make sure the device is fully charged before starting the upgrade process
  • Do not disconnect or reset the device during the upgrade process

Preparation


Upgrade Guide


  1. Run DriverInstall.exe and install RK3288 driversupgrade_01
  2. Run RKBatchTool.exe and load the image fileupgrade_02
  3. Turn off Pipo P1 and connect USB cable to PC
  4. On Pipo P1, press and hold “Volume +” and “Power” button to enter upgrade mode
  5. If Windows prompts for drivers point to folder “RK3288_Release_DriverAssitant\ADBDriver” and confirm to install USB drivers
  6. After successful driver installation the first box under “Connected Devices” will turn green, if not redo the driver installationupgrade_03
  7. Click on “Upgrade” button to start writing the imageupgrade_04
  8. Wait till you see a green line with text “Upgrade Done Success” and disconnect the USB cableupgrade_05
  9. Device will now reboot. DONE

评论

此博客中的热门博文

Landvo L200G: Shameless OnePlus One Copy

NewFronts 2017: Latest Digital Trends

Download TWRP Recovery for SOC S805 TV-Boxes